ITExamDump 에서 제공해드리는 Citrix 1Y0-350덤프는 아주 우수한 IT인증덤프자료 사이트입니다. IT업계엘리트한 강사들이 퍼펙트한 Citrix 1Y0-350 덤프문제집을 제작하여 디테일한 시험문제와 답으로 여러분이 아주 간단히Citrix 1Y0-350시험을 패스할 수 있도록 최선을 다하고 있습니다.
인재도 많고 경쟁도 많은 이 사회에, IT업계인재들은 인기가 아주 많습니다.하지만 팽팽한 경쟁률도 무시할 수 없습니다.많은 IT인재들도 어려운 인증시험을 패스하여 자기만의 자리를 지키고 있습니다.우리ITExamDump에서는 마침 전문적으로 이러한 IT인사들에게 편리하게 시험을 패스할수 있도록 유용한 자료들을 제공하고 있습니다.
만약 아직도Citrix 1Y0-350인증시험 위하여 많은 시간과 정력을 소모하며 열심히 공부하고 있습니까? 아직도 어덯게하면Citrix 1Y0-350인증시험을 빠르게 취득할 수 있는 방법을 못찿고 계십니까? 지금ITExamDump에서Citrix 1Y0-350인증시험을 안전하게 넘을 수 있도록 대책을 내드리겠습니다. 아주 신기한 효과가 있을 것입니다.
여러분이 다른 사이트에서도Citrix인증1Y0-350시험 관련덤프자료를 보셨을 것입니다 하지만 우리ITExamDump의 자료만의 최고의 전문가들이 만들어낸 제일 전면적이고 또 최신 업데이트일 것입니다.우리덤프의 문제와 답으로 여러분은 꼭 한번에Citrix인증1Y0-350시험을 패스하실 수 있습니다.
시험 번호/코드: 1Y0-350
시험 이름: Citrix (Citrix NetScaler 10 Essentials and Networking)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 126 문항
업데이트: 2014-04-16
1Y0-350 덤프무료샘플다운로드하기: http://www.itexamdump.com/1Y0-350.html
NO.1 Scenario: An engineer executes the following commands:
add vlan 2 bind vlan 2 -ifnum 1 / 2 add ns ip 10.110.4.200 255.255.255.0 bind vlan 2 -IPAddress
10.110.4.200 255.255.255.0
What type of IP address has been added to the NetScaler?
A. VIP address
B. NSIP address
C. SNIP address
D. GSLB Site IP address
Answer: C
Citrix dumps 1Y0-350 1Y0-350자격증
NO.2 A network engineer wants to optimize a published load balanced SSL virtual server for WAN
connection with long delay, high bandwidth with minimal packet drops.
What would the network engineer use to do this type of optimization for the SSL virtual server?
A. SSL policy
B. TCP profile
C. Compression policy
D. Priority queuing policy
Answer: B
Citrix 1Y0-350 1Y0-350 1Y0-350자격증
NO.3 A network engineer has configured two NetScaler MPX appliances as a high availability (HA)
pair.
What can the engineer configure to prevent failover if only a single interface fails?
A. FIS
B. PBR
C. SNMP
D. VMAC
Answer: A
Citrix 1Y0-350 1Y0-350 dumps 1Y0-350기출문제 1Y0-350 1Y0-350 dumps
NO.4 Scenario: The NetScaler is connected to two subnets. The NSIP is 10.2.9.12. The external SNIP
is 10.2.7.3. The MIP for internal access is 10.2.9.3. Web servers, authentication servers and time
servers are on the 10.2.10.0/ 24 network which is available through the
10.2.9.1 router. The external firewall has the 10.2.7.1 address. Traffic bound for Internet clients
should flow through the external firewall.
Which command should be used to set the default route?
A. add route 0.0.0.0 0.0.0.0 10.2.7.1
B. add route 0.0.0.0 0.0.0.0 10.2.9.1
C. add route 10.0.0.0 255.0.0.0 10.2.9.1
D. add route 10.0.0.0 255.0.0.0 10.2.7.1
Answer: A
Citrix 1Y0-350시험문제 1Y0-350덤프 1Y0-350인증 1Y0-350
NO.5 Scenario: The NetScaler has connections to a large number of VPNs. The network engineer
wants to minimize the number of ARP requests.
Which feature should the network engineer enable to minimize ARP requests?
A. TCP Buffering
B. Use Source IP
C. Edge Configuration
D. MAC based forwarding
Answer: D
Citrix덤프 1Y0-350자격증 1Y0-350 1Y0-350기출문제 1Y0-350
NO.6 Scenario: A NetScaler appliance currently has a manually configured channel containing four
interfaces; however, the engineer has been told that the NetScaler must now only use a single
interface for this network. The engineer removes the channel and immediately notices a decrease in
network performance.
How could the engineer resolve this issue?
A. Reset the unused interfaces
B. Disable the unused interfaces
C. Enable flow control on all interfaces
D. Disable HA monitoring on the three interfaces that are no longer required
Answer: B
Citrix기출문제 1Y0-350자격증 1Y0-350 1Y0-350 pdf
NO.7 Scenario: For security reasons, the NSIP needs to be configured to only be accessible on
interface 0/1, which is VLAN 300.
The NSIP address is 10.110.4.254 and the subnet mask is 255.255.255.0.
How would the network engineer achieve this configuration?
A. set ns config -nsvlan 300 -ifnum 0/1
B. set ns ip 10.110.4.254 -gui ENABLED -vrID 300
C. add vlan 300 set ns ip 10.110.4.254 -mgmtAccess ENABLED
D. set ns config -IPAddress 10.110.4.254 -netmask 255.255.255.0
Answer: A
Citrix dumps 1Y0-350 1Y0-350시험문제 1Y0-350 pdf
NO.8 Why would an engineer want to specify a TCP Profile for a specific service group?
A. To enable use of features like SSL over TCP for that specific service group.
B. To adjust the TCP settings for traffic to and from that specific service group.
C. To use a specific SNIP for traffic to the back-end servers in that service group.
D. To enable features like use source IP , TCP keep alive and TCP buffering for a specific service group.
Answer: B
Citrix 1Y0-350시험문제 1Y0-350
NO.9 Scenario: A NetScaler engineer needs to enable access to some web servers running on an
IPv6-only network. The clients connecting the services are on an IPv4 network. The engineer has
already enabled IPv6 on the NetScaler.
What does the engineer need to do in order to provide access to the services on the IPv6 network?
A. Create an IPv6 tunnel and a IPv4 virtual server.
B. Configure an IPv6 VLAN and bind the required interface.
C. Create a IPv4 virtual server and bind the service group to it.
D. Create an IPv6 ACL and a IPv4 virtual server and bind the ACL to the virtual server.
Answer: C
Citrix 1Y0-350 1Y0-350 1Y0-350최신덤프 1Y0-350
NO.10 Scenario: A network engineer created an IPv6 virtual server on the NetScaler. The virtual
server is using a service group with two IPv4 servers bound to it. When testing access to the virtual
server from a client configured with an IPv6 address, he is unable to connect.
What could be the reason for this issue?
A. The NetScaler is disabled for NAT.
B. IPv6 protocol translation is disabled.
C. An IPv6 address on the NetScaler is not bound to the correct VLAN.
D. The NetScaler does not have an INAT rule to convert IPv4 to IPv6 from the back-end servers.
Answer: B
Citrix 1Y0-350자격증 1Y0-350 1Y0-350 1Y0-350
ITexamdump의 MB3-701덤프의 VCE테스트프로그램과 HP0-J62덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 300-208시험에 대비한 고품질 덤프와 HP2-B97시험 최신버전덤프를 제공해드립니다. 최고품질 000-N55시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기