ITExamDump는 유일하게 여러분이 원하는CheckPoint인증156-315.71시험관련자료를 해결해드릴 수 잇는 사이트입니다. ITExamDump에서 제공하는 자료로 응시는 문제없습니다, 여러분은 고득점으로 시험을 통과할 것입니다.
CheckPoint인증 156-315.71시험을 가장 빠른 시일내에 가장 쉬운 방법으로 패스하는 방법을 고심초사한끝에 ITExamDump에서 연구해 내었습니다. 그건 바로ITExamDump의CheckPoint인증 156-315.71덤프로CheckPoint인증 156-315.71시험에 대비하는것입니다. ITExamDump의CheckPoint인증 156-315.71덤프품질을 검증하려면 구매사이트의 무료샘플을 체험해보시면 됩니다.자격증을 많이 취득하여 멋진 IT전문가로 되세요.
자신을 부단히 업그레이드하려면 많은 노력이 필요합니다. IT업종 종사자라면 국제승인 IT인증자격증을 취득하는것이 자신을 업그레이드하는것과 같습니다. CheckPoint인증 156-315.71시험을 패스하여 원하는 자격증을 취득하려면ITExamDump의CheckPoint인증 156-315.71덤프를 추천해드립니다. 하루빨리 덤프를 공부하여 자격증 부자가 되세요.
CheckPoint 인증 156-315.71시험에 도전해보려고 결정하셨다면 ITExamDump덤프공부가이드를추천해드립니다. ITExamDump덤프는 고객님께서 필요한것이 무엇인지 너무나도 잘 알고 있답니다. ITExamDump의 CheckPoint 인증 156-315.71덤프는CheckPoint 인증 156-315.71시험을 쉽게 만듭니다.
시험 번호/코드: 156-315.71
시험 이름: CheckPoint (Check Point Certified Security Expert R71)
당신이 구입하기 전에 시도
일년동안 무료 업데이트
100% 환불보장약속
100% 합격율 보장
Q&A: 480 문항
업데이트: 2013-11-06
ITExamDump을 선택함으로 100%인증시험을 패스하실 수 있습니다. 우리는CheckPoint 156-315.71시험의 갱신에 따라 최신의 덤프를 제공할 것입니다. ITExamDump에서는 무료로 24시간 온라인상담이 있으며, ITExamDump의 덤프로CheckPoint 156-315.71시험을 패스하지 못한다면 우리는 덤프전액환불을 약속 드립니다.
우리ITExamDump에서는 끊임없는 업데이트로 항상 최신버전의CheckPoint인증156-315.71시험덤프를 제공하는 사이트입니다, 만약 덤프품질은 알아보고 싶다면 우리ITExamDump 에서 무료로 제공되는 덤프일부분의 문제와 답을 체험하시면 되겠습니다, ITExamDump 는 100%의 보장 도를 자랑하며156-315.71시험은 한번에 패스할 수 있는 덤프입니다.
156-315.71 덤프무료샘플다운로드하기: http://www.itexamdump.com/156-315.71.html
NO.1 Organizations are sometimes faced with the need to locate cluster members in different geographic
locations that are distant from each other. A typical example is replicated data centers whose location is
widely separated for disaster recovery purposes.
What are the restrictions of this solution?
A. There are no restrictions.
B. There is one restriction: The synchronization network must guarantee no more than 150 ms latency
(ITU Standard G.114).
C. There is one restriction: The synchronization network must guarantee no more than 100 ms latency.
D. There are two restrictions: 1. The synchronization network must guarantee no more than 100ms
latency and no more than 5% packet loss. 2. The synchronization network may only include switches and
hubs.
Answer: D
CheckPoint 156-315.71 156-315.71
NO.2 When you check Web Server in a host-node object, what happens to the host?
A. The Web server daemon is enabled on the host.
B. More granular controls are added to the host, in addition to Web Intelligence tab settings.
C. You can specify allowed ports in the Web server's node-object properties. You then do not need to list
all allowed ports in the Rule Base.
D. IPS Web Intelligence is enabled to check on the host.
Answer: B
CheckPoint 156-315.71최신덤프 156-315.71시험문제 156-315.71
NO.3 You are establishing a ClusterXL environment, with the following topology: External interfaces
192.168.10.1 and 192.168.10.2 connect to a VLAN switch. The upstream router connects to the same
VLAN switch. Internal interfaces 172.16 10.1 and 172.16.10.2 connect to a hub. 10.10.10.0 is the
synchronization network. The Security Management Server is located on the internal network with IP
172.16.10.3. What is the problem with this configuration?
A. There is an IP address conflict
B. The Security Management Server must be in the dedicated synchronization network, not the internal
network.
C. The Cluster interface names must be identical across all cluster members.
D. Cluster members cannot use the VLAN switch. They must use hubs.
Answer: B
CheckPoint 156-315.71인증 156-315.71인증
NO.4 Check point Clustering protocol, works on:
A. UDP 8116
B. UDP 500
C. TCP 8116
D. TCP 19864
Answer: A
CheckPoint 156-315.71 pdf 156-315.71최신덤프 156-315.71 156-315.71시험문제
NO.5 Which procedure creates a new administrator in SmartWorkflow?
A. Run cpconfig, supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
B. In SmartDashboard, click SmartWorkflow / Enable SmartWorkflow and the Enable SmartWorkflow
wizard will start. Supply the Login Name, Profile Properties, Name, Access Applications and Permissions
when prompted.
C. On the Provider-1 primary MDS, run cpconfig, supply the Login Name, Profile Properties, Name,
Access Applications and Permissions.
D. In SmartDashboard, click Users and Administrators right click Administrators / New Administrator and
supply the Login Name. Profile Properties, Name, Access Applications and Permissions.
Answer: D
CheckPoint 156-315.71 156-315.71 156-315.71
NO.6 John is configuring a new R71 Gateway cluster but he can not configure the cluster as Third Party IP
Clustering because this option is not available in Gateway Cluster Properties: What's happening?
A. John is not using third party hardware as IP Clustering is part of Check Point's IP Appliance B .Third
Party Clustering is not available for R71 Security Gateways.
B. ClusterXL needs to be unselected to permit 3rd party clustering configuration.
C. John has an invalid ClusterXL license.
Answer: C
CheckPoint 156-315.71 156-315.71 156-315.71 156-315.71
NO.7 Which of the following is NOT a feature of ClusterXL?
A. Enhanced throughput in all ClusterXL modes (2 gateway cluster compared with 1 gateway)
B. Transparent failover in case of device failures
C. Zero downtime for mission-critical environments with State Synchronization
D. Transparent upgrades
Answer: C
CheckPoint 156-315.71자료 156-315.71
NO.8 How does a cluster member take over the VIP after a failover event?
A. Ping the sync interface
B. if list -renew
C. Broadcast storm
D. Gratuitous ARP
Answer: D
CheckPoint 156-315.71 pdf 156-315.71최신덤프
NO.9 You want to verify that your Check Point cluster is working correctly. Which command line tool can you
use?
A. cphaconf state
B. cphaprob state
C. cphainfo-s
D. cphastart -status
Answer: B
CheckPoint 156-315.71 156-315.71자료 156-315.71기출문제 156-315.71덤프 156-315.71최신덤프
NO.10 Which of the following commands can be used to stop Management portal services?
A. fw stopportal
B. cpportalstop
C. cpstop / portal
D. smartportalstop
Answer: D
CheckPoint덤프 156-315.71 156-315.71자료 156-315.71
NO.11 You need to publish SecurePlatform routes using the ospf routing protocol. What is the correct
command structure, once entering the route command, to implement ospf successfully?
A. Run cpconfig utility to enable ospf routing
B. ip route ospf
ospf network1
ospf network2
C. Enable
Configure terminal
Router ospf [id]
Network [network] [wildmask] area [id]
D. Use DBedit utility to either the objects_5_0.c file
Answer: C
CheckPoint pdf 156-315.71기출문제 156-315.71인증
NO.12 You are MegaCorp Security Administrator. This company uses a firewall cluster, consisting of two
cluster members. The cluster generally works well but one day you find that the cluster is behaving
strangely. You assume that there is a connectivity problem with the cluster synchronization cluster link
(cross-over cable).
Which of the following commands is the best for testing the connectivity of the crossover cable?
A. telnet <IP address of the synchronization interface on the other cluster member>
B. arping <IP address of the synchronization interface on the other cluster member>
C. ifconfig a
D. Ping <IP address of the synchronization interface on the other cluster member>
Answer: B
CheckPoint자료 156-315.71 156-315.71 dump 156-315.71기출문제
NO.13 What is a task of the SmartEvent Correlation Unit?
A. Add events to the events database.
B. Look for patterns according to the installed Event Policy.
C. Assign a severity level to an event
D. Display the received events.
Answer: B
CheckPoint 156-315.71 156-315.71
NO.14 Which external user authentication protocols are supported in SSL VPN?
A. LDAP, Active Directory, SecurID
B. DAP, SecurID, Check Point Password, OS Password, RADIUS, TACACS
C. LDAP, RADIUS, Active Directory, SecurID
D. LDAP, RADIUS, TACACS, SecurID
Answer: B
CheckPoint덤프 156-315.71기출문제 156-315.71 156-315.71최신덤프
NO.15 Control connections between the Security Management Server and the Gateway are not encrypted by
the VPN Community. How are these connections secured?
A. They are encrypted and authenticated using SIC.
B. They are not encrypted, but are authenticated by the Gateway
C. They are secured by PPTP
D. They are not secured.
Answer: D
CheckPoint 156-315.71자료 156-315.71시험문제
NO.16 Refer to Exhibit:
Match the ClusterXL Modes with their configurations
A. A-3, B-2, C-1, D-4
B. A-3, B-2, C-4, D-1
C. A-2, B-3, C-4, D-1
D. A-2, B-3, C-1, D-4
Answer: C
CheckPoint 156-315.71 156-315.71덤프 156-315.71 156-315.71
NO.17 ________is a proprietary Check Point protocol. it is the basis for Check Point ClusterXL inter-module
communication.
A. RDP
B. CCP
C. CKPP
D. HA OPCODE
Answer: B
CheckPoint기출문제 156-315.71기출문제 156-315.71 156-315.71 156-315.71인증 156-315.71
NO.18 What command will allow you to disable sync on a cluster firewall member?
A. fw ctl setsync 0
B. fw ctl sysnstat stop
C. fw ctl sysnstat off
D. fw ctl setsyns off
Answer: D
CheckPoint 156-315.71 156-315.71 156-315.71 156-315.71인증 156-315.71자료
NO.19 Which of the following manages Standard Reports and allows the administrator to specify automatic
uploads of reports to a central FTP server?
A. Smart Dashboard Log Consolidator
B. Security Management Server
C. Smart Reporter Database
D. Smart Reporter
Answer: D
CheckPoint시험문제 156-315.71 dumps 156-315.71자격증 156-315.71
NO.20 Which of the following statements about the Port Scanning feature of IPS is TRUE?
A. The default scan detection is when more than 500 open inactive ports are open for a period of 120
seconds.
B. The Port Scanning feature actively blocks the scanning, and sends an alert to SmartView Monitor.
C. Port Scanning does not block scanning; it detects port scans with one of three levels of detection
sensitivity.
D. When a port scan is detected, only a log is issued, never an alert.
Answer: C
CheckPoint최신덤프 156-315.71 dumps 156-315.71자료
ITexamdump의 1Z0-478덤프의 VCE테스트프로그램과 000-122덤프는 한방에 시험을 패스하도록 도와드립니다. ITexamdump 에서는 최신버전의 HP0-S33시험에 대비한 고품질 덤프와 LOT-442시험 최신버전덤프를 제공해드립니다. 최고품질 LOT-406시험자료는 100% 간단하게 시험패스하도록 최선을 다하고 있습니다. IT인증시험패스는 이토록 간단합니다.
댓글 없음:
댓글 쓰기